Need an additional caliper for the rear brake? Then NICECNC twin caliper brackets are exactly what you need. They allow you to mount an additional factory caliper on the trailing arm for a true drift setup.
Features:
- 0.5"/12mm high strength steel material.
- These welded plates are only compatible with BMW E36 (except Compact) and E46 calipers and disc brake trailing arms.
- Can be fitted with an additional pair of rear calipers. This solution is ideal for drifting, and hydraulic handbrakes can be installed on separate and independent hydraulic circuits.
Item specifics:
Condition: New
Type: Dual caliper adapter
Material: High quality steel
Note:
The ABS sensor must be removed.
The original caliper of a similar car (with the same engine/brake disc size) must be used.
To install the caliper correctly, the brake dust shield must be cut.
Fitment:
For all E36 rear trailing arms (except Compact)
For all E46 rear trailing arms (except Compact)
BMW E39 520i/523i/525i/530i (M52/M52TU/M54 engine)
BMW E83 25i/30i (PreLCI M54 engine)
Installation Note:
DOES NOT WORK WITH E36/E46 318ti MODELS
Disclaimer:
Nicecnc parts are not sponsored or endorsed by, or affiliated with the brands its parts fit, including Porsche, Subaru, Jaguar, BMW, Isuzu, Chrysler, Dodge, Jeep, Buick, Cadillac, Chevrolet, GMC, Volvo, Land Rover, Oldsmobile, Pontiac, Ford, Lincoln, Mercury, Acura, KIA, Nissan, Infiniti, International Harvester, Mitsubishi, Audi, Lexus, Toyota, Mazda, Volkswagen, Suzuki, Saab, Honda, Alfa Romeo, Saleen, Mercedes-Benz, Nash, Hummer, Freightliner, Datsun, Saturn, Turner, Geo, Lada, Fiat, Daihatsu, Opel, Vauxhall, Sabra, Tesla, Ram, Rover, Skoda, Healey, Mini, Smart, Scion, Renault, Seat, Peugeot, Merkur, Astra, Tucker, VW, Routan, Tiguan, Touareg, Jetta, Gti, Passat, Golf, Bosch, Denso, Holden, Chery, Mercedes Benz, Holden Special Vehicles, Hyundai, Trabant, Citroën, Freightline etc.
